So I just want to do a cam for the mean time and if it's roller ready when I swap my heads I can do a roller cam. Thanks guys the motor Is a 88-95 replacement crate motor from summit and I'm not sure if they come roller ready. I'm new to tuning tbi and just getting into it myself but with the cam you have picked and a good flowing head I would say somewhere in the 330 hp range which I don't think will quite get you there. To make the kind of power you are going to need to get in the 13 range I would definitely go with a good flowing head and bigger cam. You can also buy the springs and lifters as a kit with the cam from them. I would look to lunati website for recommendations on spring pressure and installed height. I've had a few spells of bad luck with k motion but that may just be the engine I have had them on is hard on valve train. On the springs others opinions may be different but I have used lunati and comp springs both with great results. The block should have the bosses already there but you may have to drill and tap them to go to the roller setup but there are a lot of roller grinds that can make more power and still stay streetable. I agree with the other suggestions also on going roller. I think the cam is a good choice for a 350 daily driver but if you are going to turn that kind of power I would definitely go larger.

But pickups are relatively heavy and it's going to take quite a bit of power to put one in that range.much more than it would a 3000lb car. Think ur gonna have to spray that thing to get into 13's. Thanks,I personally would not use Trickflow nor would I expect that cam to break into the 13s. I'm also looking to get trickflow heads but not for a while.Īs for the lunati cam would that be a good choice? what would be some good valve springs to pair up with the cam? and as far as tuning goes would it be extremely difficult for a beginner like me? I'm not opposed to paying someone to burn a chip for me. but within the next couple of months I'm looking forward to doing cam/valve springs/intake I haven't taken the truck to the track yet but I'm really hoping to have it break into the 13's at some point with the tbi system. after reading about and searching tbi cams i think i have narrowed down to my selection to the lunati voodoo 256/262 Im really wanting to cam my truck and pick up a few ponies.

Headman headers with y pipe 3'' full exhaustģ73 gears (possible upgrade to 411 because i upsized to 20'' wheels) I have a few questions about what I'm wanting to do and it seems like everyone here has some great answers.Īt the moment i have a 1990 chevy pick up regular cab short bed.

Hi guys I've been lurking around this website for a while now trying to learn about tuning my tbi system.

350 tbi lunati cam